June 11, 2018 | International, Aerospace
Yokota airmen improve gas mask with 3D printer, potentially saving Air Force $8 million or more
By SETH ROBSON YOKOTA AIR BASE, Japan — Tokyo-based airmen used a 3D printer and American ingenuity to modify a standard-issue gas mask into an aircraft oxygen system, potentially saving millions of dollars and improving aircrew safety. The idea of hooking up the M-50 joint-service, general-purpose mask to an aircraft was hatched during brainstorming sessions by airmen from Yokota's 374th Maintenance Squadron and 374th Operations Support Squadron. “We took the mask and added some off-the-shelf parts and some 3D-printed parts and converted it into a piece of equipment that can work in an aircraft,” said Senior Master Sgt. David Siemiet, an aircrew flight equipment superintendent. Gear used now — the Aircrew Eye/Respiratory Protection System, or AERPS — is expensive, heavy and fault prone with long waits for replacement parts, said C-130 Hercules pilot Capt. Matthew Kohl. When the ubiquitous, light and cheap M-50 is connected to an oxygen system, air flows through its chemical filters to the user, whose eyes are protected by goggles, Siemiet said. To build their prototype, the airmen looked at an Army system that hooks soldiers' masks to air blowers to overcome the stifling environment inside a battle tank. The airmen came up with a cap that blocks airflow into one side of the mask and an adaptor that allows it to attach to a hose that can be plugged into an oxygen system. The modification, which the airman call “AERPS Ultra,” uses a few standard parts and two components made on a 3D printer that aircraft materials technology craftsman Sen. Airman David Petrich bought for a few hundred dollars of his own money. It costs only about 75 cents to modify one mask, and the project has the potential to save the Air Force at least $8 million and countless man hours, according to Tech. Sgt. Eric Lundeen, another aircraft materials technology craftsman involved in the project. The M-50 weighs less than a pound, a lot less than the 40 pounds of chemical-protection gear now used by aircrew. Unlike the current system, the lighter masks don't need a power supply that must be hooked to on-board electricity and uses expensive batteries, Petrich said. “You can wear the mask onto the plane and latch in and you are good to go,” he said. The mask modifications can be done on base without the need to pay a contractor, Siemiet added. https://www.stripes.com/news/yokota-airmen-improve-gas-mask-with-3d-printer-potentially-saving-air-force-8-million-or-more-1.531504